COMBINATION SAUNA 211 VALERO+ BUILT-IN

If you cannot choose between a traditional sauna and an infrared cabin, then a combination sauna is for you! You can enjoy an infrared session or a sauna session in a combination sauna. An infrared cabin does not take long to get up to temperature and is therefore ideal for "in between" sessions. You can always use the traditional Finnish sauna if you have a bit more time. For traditional Finnish sauna, you preheat the cabin for half an hour to three quarters of an hour. The 3.6 kW 230-volt oven brings your cabin to a maximum of 80 degrees. Here you can also make infusions with different infusion concentrates as you wish.

Stove selection at SuperSauna

Proven & proven sauna heater:

Design Tower 4.5 kW / 6 kW / 9kW - 380 volt with internal control (left)

• Sawo ARI3-45 / ARI3-60 / ARI3-90
• Power: 4.5 kW / 6 kW / 9 kW
• Connection: 380 volt three-phase current
• Operation: Internal control with 2 buttons 1. Temperature / 2. Time
• Stove dimensions: 275 x x 925 x 275 mm (width / height / depth)

Cable and stones included

Electric 4.5 kW / 6 kW / 9kW - 380 volt sauna heater with internal controls for wall mounting (centre)

• NARVI NM
• Power: 4.5 kW / 6 kW / 9 kW
• Connection: 380 volt three-phase current 
• Operation: Internal control with 2 buttons 1. Temperature / 2. Time
• Dimensions heater: 430 mm x 580 mm x 300 mm (width / height / depth)

Wall mounting is not possible as the stove cannot then maintain the required distances.

Electric 4.5 kW / 6 kW / 9kW - 380 volt sauna heater with internal controls for frame mounting (right)

Corresponds to the wall-mounted stove. Only a base is supplied and the stove is mounted in the kacherek.

• NARVI NM
• Power: 4.5 kW / 6 kW / 9 kW
• Connection: 380 volt high-voltage current
• Operation: Internal control with 2 buttons 1. Temperature / 2. Time
• Oven dimensions: 430 mm x 580 mm x 300 mm (width / height / depth)
• Frame dimensions: 630 mm x 555 mm (+ 4 adjustable feet approx. 65 mm long) x 405 mm (width / height / depth)

Cable and stones included.

The infrared cabin is equipped with Infraheat™ Intense emitters, which provide a good depth effect. The Infraheat™ Intense emitters are installed to work on the back, legs and calves. The Infraheat™ Intense emitters in the back area work on the muscles and nervous system from the lower back to the neck. This part of the spine is where most muscle and joint pain occurs. In the front section of the cabin (left and right or in the front panel), you will find more Infraheat™ Intense emitters that effectively treat knee problems, rheumatic hand pain and osteoarthritis. The last Infraheat™ Intense radiant heater is located behind the calves under the bench seat and is the only radiant heater that can be switched on and off separately. This calf radiator can otherwise be unpleasant for varicose veins.

Furthermore, you get two Infraheat™ Nano-Carbon XL radiators in the side walls. With these Infraheat™ Nano-Carbon XL, you get nice, mild infrared heat for shoulders and neck in a relaxing position.

Optionally, this infrared cabin can also be equipped with Infraheat™ Full-spectrum radiators. This is always done in consultation with the customer. The full-spectrum radiator also has a short-wave section, infrared a (IR-A). This wavelength has the fastest, deepest effect and is recommended for rheumatic and arthritic complaints.

In just a few minutes, your cabin is warmed up and ready to use thanks to the patented Infraheat™ technology. The specially developed Infraheat™ Intense radiant heater provides intense heat with a good depth effect to relieve muscle and joint pain. In our quality infrared cabins, people have been experiencing the benefits of this infrared heat for years. The Infraheat™ Intense radiator is a long-wave radiator (IR-C) with transition to medium-wave (IR-B). Experience the wonderful intensive depth effect and feel reborn after every infrared session! This cabin is complemented by two carbon radiators, which provide lovely, mild infrared heat on the shoulders and neck. Thanks to our combination of the different infrared emitters, this cabin has a relieving effect on muscle and joint pain, rheumatic and arthritic complaints and also fibromyalgia.

Wood selection SuperSauna®

For most models, you can choose between two different types of wood: hemlock or Canadian red cedar (additional cost). Before the wood is finally processed, both types are dried in special drying ovens. This process removes moisture from the wood, which is important so that the wood does not "work" afterwards. Another great advantage of these two types of wood is that they are almost knot- and splinter-free. This makes these woods extremely durable and a purchase for life. Canadian red cedar has another special feature. This wood species has an antibacterial oil, which is fungicidal and bactericidal.

But maintenance is also important. You should wipe the cabin with a damp cloth without detergent after each use. After wiping, simply leave the door open and let the cabin air out. To minimise work and the risk of sweat stains, we recommend using plenty of towels. One towel on the bench, one on the floor and one to take sweat off your body. If you keep sweating permanently during a session, try to cool down your body further and you will continue to sweat freely. For extra hygiene, you can purchase a sauna pillow from us. If you sweat through the towel, the stain will end up on the cushion and not on the wood. Just wipe off the cushion and you're done. No stain in the wood. Once the stain is in the wood, we recommend wiping the area over a large area and letting it air out.

Advantages of SuperSauna® infrared cabins

At SuperSauna®, we strive to provide customers with reliable information and comprehensive advice when purchasing their dream infrared sauna. Our priority is not only sales, but also after-sales service. At SuperSauna® we have and give:

Customer satisfaction

Feel free to check out the reviews of customers who are already satisfied SuperSauna® owners. Customer review SuperSauna.

Shops in 4 countries

• The largest selection of therapeutic infrared saunas on display
• More than 15 years of experience selling high-quality infrared cabins
• Shops with a wide range and the best specialist advice (come and see and compare)

Durable Infraheat™ radiant heater

• Lifetime warranty on Intense and Carbon radiant heaters!
• Always the latest generation of Infraheat™ infrared heaters
• Possibility of combining 3 different types of emitters in one cabin
• Medium and long wave therapeutic Infraheat™ emitters (optionally also a short wave section)

Therapeutic effect

• Relief of muscle and joint pain
• Detox function in the infrared cabin (up to 75C)

Even more advantages

• Very nice finish
• Double-walled design
• We only use safety glass
• Ergonomic backrest included
• Hemlock and Canadian red cedar of the best quality
• You can assemble most saunas in 60-90 minutes
• Thanks to the Build-and-Go system, it is also easy to dismantle and relocate
• Simple and intuitive operation
• Digital control panel on the inside of the infrared cabin
• Audio system with 2 speakers. Radio, Bluetooth and USB function controllable via control panel
• Connection 230 V, normal socket
• Heated within minutes by the latest Infraheat technology
• Temperature from 35C to 75C degrees, much more pleasant than traditional saunas

Radiant selection at SuperSauna®

At SuperSauna®, we have relied on high-quality infrared radiators from Infraheat™ for more than 15 years. The emitters have been tested for 20,000 burning hours. This equates to around 40,000 sessions. With SuperSauna®, you get a lifetime warranty on these quality infrared heaters.

The most important question you should ask yourself is: why do I want to buy an infrared cabin?

This reason determines which type of infrared emitters and cabin you should choose.

Infrared cabins are used for several reasons.

The most frequently given reasons

• Relief of muscle and joint pain
• Post-workout muscle recovery
• Reduce stress and relax after a hard day
• Strengthen your immune system
• Skin diseases
• Train heart rhythm
• Lyme disease
• Improve sleep
• Burn calories
• Detoxify / Purify

The shortwave infrared (wavelength 750nm - 1400nm)

The shorter the wavelength of infrared, the more heat is produced on the skin and the shorter you can use. This makes it difficult for our bodies to absorb this type of infrared radiation properly. This form of infrared radiation has the advantage that it penetrates slightly deeper into our bodies. For this reason, the first clinical studies (before 1998) were mostly positive about this type of short-wave infrared radiation. However, later studies concluded that long-wave infrared radiation has advantages. The average use time of shortwave is only about 10 minutes per session.

Long-wave infrared (wavelength 3000nm - 10.00nm)

The long-wave infrared radiation goes slightly shallower than the short-wave, but is much better absorbed by our body. For this reason, the best therapeutic results are usually achieved with this type of infrared radiator. For deeper pain (e.g. a hernia), using a shortwave radiant heater can be advantageous. In the SuperSauna® specialist shop, we will be happy to explain to you how to make the best use of the combination of different heaters.

Recording more important than depth!

In the past, the main focus was on the depth effect of infrared. However, it was later discovered that infrared absorption is much more important. For this largely determines the therapeutic effect. As a result, most clinical studies* (after 2002) support long-wave infrared more than short-wave infrared.

Infraheat™ Intense

We have been using Infraheat™ brand radiators for years. These radiators have been specially developed to relieve muscle and joint pains. The heater is a long-wave heater with an extension to the middle wave and made of a special ceramic magnesium oxide material. Because the Infraheat™ Intense generates mid-wave as well as long-wave infrared, this radiation has a good depth effect on the body. This depth effect is important for relieving muscle and joint pains. With years of proven performance, Infraheat™ Intense is a reliable choice.

Infraheat™ Carbon

Carbon radiators are known for the nice, mild heat in the infrared sauna. We use the Infraheat Carbon emitters in combination with the Infraheat Intense emitters to create a perfect heat balance in the IR cabin. The Infraheat Carbon radiators are usually placed in the side walls of the IR cabin as an addition. This allows you to experience wonderful infrared heat on all sides of your body, while still receiving mild heat on your back in a relaxed position. This unique combination of emitters provides an infrared experience that is unique in Europe.

Infraheat™ Full Spectrum

Infraplus makes it possible to equip your cabin with infraheat full spectrum emitters (optional). This gives you not only medium- and long-wave infrared ir-heat but also a section of short-wave (IR-A). In consultation with the customer, we provide the perfect balance in your ir sauna. The full-spectrum emitters can be placed on customer-specific wishes so that a suitable configuration is possible for everyone.

Installation of your SuperSauna®

Assembly is kept very simple by prefabricated elements and is feasible even for a layman. You only need to assemble 9 parts. You do this easily with our clear assembly instructions. The points where benches, backrests and other parts should be attached are already pre-assembled. You don't need to measure anything anymore. Just hang it up and screw it on.

Installing accessories

Colour therapy lamps: The colour therapy lamp is attached to the inside of the roof. All you have to do is drill a hole for the cable and screw on the panel lamp with 4 hooks. Don't cut and let in, just put it on.

Full-spectrum emitter: Place the full-spectrum emitter instead of an intense emitter. To do this, remove the built-in intense emitter and replace it with the full-spectrum emitter.

Underfloor heating: The underfloor heating is placed on the floor. You need to drill a hole in the calf emitter plate so the cable is not pinched and connect it to the back wall with a Y connector.

Here you can see how all SuperSauna cabins are installed. The video shown is about the 2 Trendy.